Installing a new water heater is a critical step for your home, guaranteeing a steady hot water supply. However, one more thing to note is how to use it correctly, which begs the question, how long should it take to run water after a new water heater? For your safety and the efficiency of your system, the following are the steps to take.
Step 1: Fill the Tank
The most important step is to fill the tank. Start by closing the valve below the tank and opening cold water from the supply valve. This will let air escape as the tank fills up. Do not turn on the heater first; let the water keep running until the tank is full.
Step 2: Run the Water
Once the water fills the tank, the next thing to do is to run the pipes to help clear unwanted debris from the system. Note that the timeframes for running the water depend on your hot water system design. If you had a tankless water heater installation in Cartersville, you would need a shorter time to run the water.
For such systems, you need to run water for only 5-10 minutes, considering that the heaters don’t usually store a lot of water. This time will be sufficient to clear out any debris resulting from installation. So, how long should you let water run after a new tank-style water heater installation? Given the design style of the system, you will need to run water through for a longer time, for at least 20-30 minutes after it has been installed.
Step 3: Monitor the Heater
One more important thing to do after installation is to monitor how the system works, checking for any issues. Watch out for leaks, unusual noises, or heating issues. This means there was a problem during installation, and you should immediately address it to avoid more serious problems later on.
Step 4: Maintenance
Even when everything is working fine, you will still have to check for issues like water pressure, sediment buildup, and the condition of the anode rod. If not, the water system may have issues down the line. For instance, ensure regular descaling of your tankless system and contact professionals in case of any unforeseen circumstances.
Let Professionals Handle Your Installation
A lot of work goes into installing a water heating appliance in your home. That’s why you need to hire experienced contractors from A-Total Plumbing to help—from the installation to the monitoring and maintenance stages—for the smooth running of your system.
Whether you’re dealing with Yard Leaks, Water Heater Leaks, Whole House Stoppages, Hot Water Issues, Toilet Problems, Faucets, or Gas Leaks, our expert team is here to provide reliable solutions for all your plumbing needs.
